Spec Sheets: TTS Remote Pump System

TTS Remote Pump System Manual

Oil Crawler Used Oil Recovery System

• ¾” Air Diaphragm Pump System 16 GPM

Compatible with the following products:

• New/Used engine oil
• New/Used Hydraulic oil
• Pressure gauge
• Pressure regulator

• ¼” ball valve for controlling the air supply of the TTS Remote Pump System
• One(1) Male quick coupling
• Pump outlet: ball valve
• Automatic high level alarm sensor (shuts off air supply to pump). NOTE: This level sensor needs a 2” NPT female opening in the tank top.
• Alarm module with Audible (siren) & Visual alarm (strobe light).
• Timer for hand-free operation. In case of high or low level situation, the pump will still shut down automatically.
• Pump Station dash/panel that enables either a table top or wall mounted configuration with-out any additional equipment. Just reattach the pump on the desired pre-drilled location to have it table top or wall mounted.
• Brushed 36” long aluminum suction tube/wand with wall bracket
• 12 ft long suction hose for connecting the suction tube or the wall mount funnel to the pump station.
• Quick connect coupler for connecting either pick-up wand or wall mount funnel.
• 50 ft of signal wire between the level gauge sensor and the pump station panel.
• Two (2) - Power supply, low voltage(12V) transformer c/w 10 ft long cords, for the pump station control unit and alarm module.
• One (1) – 3/8” ball valve to cut the main air supply to the pump station unit.

NOTE: The storage tank must be equipped with one (1) x 2” NPT and one (1) x ¾” NPT female fittings for level sensor and pump outlet installation.